In addition to reference method gas analysers, Signal Group also manufactures a full range of sample handling, calibration and test instruments; making Signal a one-stop-shop for emissions monitoring equipment.
This gas divider provides ten fixed points for checking instrument linearity across the full measurement range. The instrument is suitable for use with any gas compatible with st-st, ptfe and kynar materials.
This device is used to check the converter efficiency of Chemiluminescent NOx analysers during manufacture and after every 6 months of operation. The NOxGen 3 provides the option of remote control using TTL levels for all operational functions.
An external non-methane hydrocarbon cutter provides the capability to measure methane-only for clients with a standard heated flame ionisation detector (FID). The 320 therefore provides a low cost alternative to all-in-one FIDs with a built in cutter.
Provides an inexpensive source of clean, zero-grade air for flame ionisation detectors (FID). Removes all hydrocarbons, including methane, down to 0.1% of the original level. Up to 10 FID units can be run from one unit.
In addition to reference method gas analysers, Signal Group also manufactures a full range of sample handling, calibration and test instruments; making Signal a one-stop-shop for emissions monitoring equipment; Heated sample handling units, Cooler dryers, Methane cutters, NO2 and NH3 to NO Converters and Test & calibration equipment.
Get in touch to discuss our Ancillary Equipment.
Levels of uncertainty in gas measurements can be increased, for example, by calibration gases that offer poor levels of accuracy. For this reason, Signal Group
Responding to a demand for short-term monitoring, Signal Group has established a fleet of gas measurement instruments that are available for hire. “Some of our
Loved and adored by his family and friends, much liked and admired by his peers, John Clements was a hugely popular man, and will be
Company Registration Number 01369865 • Vat Number GB296290719
